Forum Replies Created
-
You actually need the GOLF VR6 Syncro parts & not the Passat ones
I dont have one here, But I can get you one from the local breakers yard.
Yes, there was a new one on there last month & the mupppet wanted 350 euros for it!
I just emailed you about this [
]
I have the lhd steering rack pipework here for you, including the pump & even the lhd steering rack if you need it?
Some hubs have, some dont, you will have to check if yours does.
The ABS ring does not fit onto the disc, it over the outer CV joint inside the hub.
It is a lot easier to fit everthing in one go as I did, VR6 beam, wishbones, driveshafts etc
yes, its the mk 2 SYNCRO carrier on the mk 4 caliper, & also yes its with the 239 X 10 1.05 Disc or with spacers the 239 X 12 1300 disc
see above links
btw. The 2wd 226mm rear brake setup is NOT compatable with the with the Syncro 239mm rear disc brakes
Digifant 2 for the 98bhp & Digifant 1 for the 160 bhp G/lader motor.
On the G2 syncro the relay & fuse boxes are pinned out differently & some of the fuses & relays sit in different places to the 2wd Golfies
The tank sender has to be in the same place, I.E. in the tank! however it might be shown differently on the wiring diagram.
I think I have a Syncro fuse box & relay drawing somewhere I will look tomorrow
I notice that as its an American site there is no reference to the Golf Syncro, as it was never imported there.
V2 of the vwsyncro.co.uk forums
