jonny-5

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Mk2 Syncro rear axle mounts #21416
    jonny-5
    Participant

    There’s a set on eBay at the moment if you’re still after them (not mine by the way) Pricey though!

    https://www.ebay.co.uk/itm/222336679758

    in reply to: Syncro rear back plates/splash guards #11294
    jonny-5
    Participant

    Here’s what I did in the end:

    I bought these from german ebay
    ebayde_zpspeiskqwg.jpg
    They are from an A3 quattro or mk4 golf 4 motion Part number is 1J0 615 611 C / 1J0 615 612 C, the two part numbers correspond to the position of the ABS sensor hole but that does not matter in this instance since the VR6 ABS sensor is perpendicular to the driveline. I pick these ones just because they looked the closest match to the originals.

    Then I traced the mounting holes from the originals over to the new ones made a jig to mount it on and cut away with a pad saw and a die grinder. Sorry for lack of pictures of this operation, but this is the end result after paint and lacquer:

    IMG_1913_zpsbia7lqy7.jpg

    Look pretty neat and fit perfectly with mk4 calipers!

    IMG_1915_zpspjhjjcyg.jpg

    IMG_1914_zpsih23v0u2.jpg

    in reply to: Syncro rear back plates/splash guards #11286
    jonny-5
    Participant

    Thanks again housey. Tempted to try some 4 mo ones and mod them. Might just cut away the really rusty bits and spray them

Viewing 3 posts - 1 through 3 (of 3 total)

V2 of the vwsyncro.co.uk forums

Site and hosting by Plus8.net
Firebeans crystal healing (new wordpress site) | Firebeans crystal healing (old site)