Forum Replies Created
-
AuthorPosts
-
Chris S
ModeratorThey were last summer when I got my new one.
I will check this week and see [
]http://www.vwsyncro.co.uk/data/forums/topic.asp?TOPIC_ID=1693
Chris S
ModeratorThere is an anti roll bar if thats what you mean?
its nr 6 in the drawing
Chris S
ModeratorAs usual we will do our best to help. [
]btw there is no such thing as a daft question, only daft answers [
]Chris S
ModeratorIt helps a lot when you have copies of ETKA going back to 1999!
Unfortunately the earlier one is deleted on my system as well [
]Chris S
ModeratorThe early one is P/N 02C 409 126
The later one is P/N 02C 409 126Ayou can find part numbers at vagcat.com
Chris S
ModeratorGlad to have been of service [
]Chris S
ModeratorI just checked & the propshaft flange for the early type (without oilways) is no longer available from the dealer over here either,
I am not sure but I think rallyemike may have a used one, you could always email & ask him.
Chris S
ModeratorDo you know if you have the early or late type gearbox? (thats either with or without oilways from the gearbox to the transfer box?)
also it it the flange to the propshaft or the right hand front driveshaft?
I can then check with my dealer to see whats available
Chris S
ModeratorI just looked in Etka and the part numbers are the same for the Country, so they should fit without any problems.
Chris S
Moderatorquote:
Originally posted by ld50What they don’t mention is that of those 500 young people who die in RTAs – how many of them have drink or other substances in their system or were just driving like twats – perhaps they should ban those things? oh they did – didn’t work…blame it on modded cars instead

Bloody hell, I didn’t know that twats were banned in the UK! [:0]
Chris S
ModeratorIf you get the fuel tank try and make sure to get the filler neck as well, as this is also Syncro specific.
Chris S
ModeratorBTW The rims are only 6 inch wide rims, but I don’t think that you will find 6.5 inch rims that easily,
At 140 pounds hopefully that is for a set! [
]Chris S
ModeratorChris S
ModeratorChris S
ModeratorThe LHD 2wd tubular one also comes too close to the transfer box and prop shaft,
I measured it when I had one here, its a simple enough slice and weld job to modify it and fit it to the lower half of a syncro downpipe though,
what you finish with is something like this 8v one on the left

-
AuthorPosts
