[Rellacott14]

Apparently the spline needs cutting down to accept the 100mm cv joints.

Is it removed off both inner and outter splines?..

[Rellacott14]

Is there any chance you could help with this driveshaft form?

http://www.sqsracing.com/files/fs_files/contentpages/21/drive-shafts-custom_118.pdf

Im using the haldex conversion kit with vr6 trailing arms I know the g60 shaft’s needs to be shorter but im unsure and need an accurate specification.

Thanks in advance

[Rellacott14]

Hi. Im having a pair of rear drive shafts made.
Can you tell me the length of the rear shafts without the cv joints?

Thanks

[Rellacott14]

I also ordered these. Get them Friday so hopefully they will work. If not I found these universal 25mm poly bushes with clamps I think I might use instead.

http://www.racingxs.co.uk/index.php?route=product/category&path=2_29

Rick.

[Rellacott14]

Hi Chris. Did you get to try these clamps and rubbers?
Iv just ordered a 25mm sway bar. I was wondering if they would work for the inners and outers?

Rick.

[Rellacott14]

Hi all! My names rick.
About time I joined this forum. I own a H reg 3 door mk2 golf thats currently off the road waiting to be converted into a syncro/haldex beast! So far iv got the vr6 subframe and got a corrado vr6 transmission tunnel. Need the dutch build haldex conversion kit etc etc. I wont bore you!..

Up fronts going to be a 2L 16v turbo. Aiming for 600+hp shame it takes so long to save up for the parts!

Ill get a thread started at some point []

[Author]

Posts