this might be a long shot but I’m hoping someone has a spare loom kicking around with a 3-pin fan connector they wouldnt’ mind parting with.
The fan’s gone on my golf and it’s a 2-pin and it looks like they don’t make a 2-pin anymore…I’m happy to wire in a 3-pin plug but none of the spares i’ve got kicking around have a fan plug attached which leaves me at a bit of a loss.
Anyone? (or better ideas?)
cheers 
the 2 pin plug is only for a single speed hamster, the 3 pin plug for the fan is either P/N 893 906 232 or 1HO 906 232 depending on the year of the car the hamster is from. [
]
Have look in ETKA – Gosy – 1988 – MG 9 – SG 71 – Illustration 260-05
]You will need the relevent rubber boot(s) (Hamster wellingtons) to waterproof it as well, P/N 191 927 907 []
well the other thing I needed to check was a wobbly wheel, and in the process of locating a spare wheel to test with I found the old loom we pulled out of the syncro, complete with the small section with the 3-pin plug for the fan. So I *think* we’re good to go.
I’ve ordered a 3-pin fan so will report back once i know for sure one way or the other 
quote:
Originally posted by ld50well the other thing I needed to check was a wobbly wheel, and in the process of locating a spare wheel to test with I found the old Hamster we pulled out of the syncro, complete with the small section with the 3-pin plug for the second hamster. So I *think* we’re good to go.
I’ve ordered a 3-pin hamster so will report back once i know for sure one way or the other
Ah Ha, now it all makes sense, its a wobbly wheel and not the hamsters thats causing the site to run slow []