[Joes]

so any one in the UK got any?

[Joes]

ok, it is to go onto my mk1 golf 4wd the ones i have got now i converted to run on disks anyway so all i actually need is just the wishbones then selves so dont need brakes or disk or drums or anything

i presume the passat ones are exactly the same?
how much you looking for?
thanks Joe

[Joes]

one set one left and one right

depends on the price of the P&P
and how much you wont

[Joes]

i run a solid engine mount on my mk2 20vt to stop the engine movement as i was having problems with the enigine to much in comparisson to my dads mk2 which runs all the original rubbers. youd never know the difference but well see when things are running.

[Joes]

hi Mike
thanks for the positive comments, i’m using the mk4 golf rear diff not the mk5 one.

the propshaft i have been in and dated about this problem but i have got a 4motion shaft and shortened it so i will be running the rubber i just havent put it on my forum yet lol.

cutting and shortening driveshafts was a bit worrying as i have never considered doing things like this before it turned out quite good though but the proof will be when i get it going lol.

ive got the haldex controller back in one piece now

thanks Joe

[Joes]

hi mike
il try and bung it back together in the next couple of days, i think you will have to do away with the pcb and run them off your own controller.

plan is sounding good i was thinking also a 3 position switch so one position would be an off the second position being a manual on to whatever the pot is set at and three being an automatic running off a pressure simular to the controller shown on the first page. but as you said maybe not straight away though.

how far away am i from being ready well im building a mk1 golf r32 also built the haldex in the back hense all of this lol. still got a bit of work to do yet but 90% of the running gear is in inc engine and ecu still got to map it yet though so shouldnt be massively long but not for a little while yet.
(http://www.clubgti.com/forum/showthread.php?t=209507)

thanks Joe

[Joes]

hi
i do have a haldex controller lying about but it is in pieces as i was going to have a go at making my own controller myself i dont think iv’e got enough knowhow to do it if you want i can try and put it back together and bung it in the post or do you just need the bi-polar stepper motor and temp sender?
how exactly were you planning to control?

thanks Joe

[Joes]

hi
do it as a rotary (potentiometer)

i will be interested in one of these when completed

thanks Joe

[Author]

Posts