boomsly

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Haldex wiring #6896
    boomsly
    Member

    and how where you achieving that?

    in reply to: Haldex wiring #6894
    boomsly
    Member

    im planning on running motec for the engine and dont have access the whole loom nor will i have the relavent sensors required for the haldex to be working as it was.

    can you recomend controller for my application?, i need it for daily use so needs to be able to be turned of for parking,plus i will be using the car on the track and drag stip too lol so ineed it to be readily turned on/off.

    what one did you use?

    i have seen a few controllers but im not sure if i need any inputs to them or if they just work as 50/50 or 100f/0r or anything inbetween via a switch

    great help so far this is the last hurdle for me and im really anxious to get it sorted

    in reply to: Haldex wiring #6892
    boomsly
    Member

    ok maybe you could point me in the right direction, i have the 02m gearbox and the rear haldex diff out of a tt and it is going into a mk1 golf, do you know what i would need to control the haldex?

    i realise it usually uses the can bus but i dont have that and dont know how others have done it(haldex scirroco, mk1 golfs, rallyes etc)

    in reply to: Haldex wiring #6889
    boomsly
    Member

    so if you have a car that never had haldex before and fited it and use a controller does the controller need any inputs at all?

    ie this controller
    http://thettshop.com/performance.asp?cat=3066&product=600427

Viewing 4 posts - 1 through 4 (of 4 total)

V2 of the vwsyncro.co.uk forums

Site and hosting by Plus8.net
Firebeans crystal healing (new wordpress site) | Firebeans crystal healing (old site)