Tightening torques 02C transmission

› Forums › Repairs & Technical › Repairs & Technical for Golf & Passat cars › Tightening torques 02C transmission

  • This topic has 2 voices and 5 replies.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 9, 2014 at 6:03 pm #1887
    Housey
    Participant

    Hi. i’m doing a thorough inside clean (pluss diff bearing replacement) on the 02C box i’m using for my 16vt project.

    does anyone have the complete list of tightening torques on this box? :)

    /Dan

    September 9, 2014 at 8:54 pm #10782
    Chris S
    Moderator

    I will post them for you when I get out of hospital after my operation.

    September 10, 2014 at 5:16 pm #10784
    Housey
    Participant

    thanks chris :)

    September 16, 2014 at 7:25 pm #10791
    Housey
    Participant

    you out of the hospital yet chris? :)

    the box is back together, but i don’t have the torque for the angle drive..

    i wild guess is that the housing bolts are 25nm. but the big nut on the flange for the prop-shaft? :)

    September 18, 2014 at 9:18 pm #10792
    Chris S
    Moderator

    sorry, I am in a lot of pain & I forgot!

    all transfer box mounting bolts (both sides) are 40NM

    but the big nut on the flange for the prop-shaft?

    265NM Yes thats Two hundred & sixty five newton meters

    September 19, 2014 at 4:16 pm #10793
    Housey
    Participant

    no problems chris. best is that you get well soon :)

    and thanks.

    265nm is the same as wheel bearings on Mk2 golfs :) should be interesting to try that one (i’ve got a torquewrench that goes from 200 to about 800nm (almost 1.5meters long))

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.

V2 of the vwsyncro.co.uk forums

banner for shortlands vehicle recovery and repairs, baskingstoke and M3 area
Site and hosting by Plus8.net
Firebeans crystal healing (new wordpress site) | Firebeans crystal healing (old site)