100mm Inner CV joint part no

[blue95]

I have a golf carb syncro front right driveshaft, does anyone have the part number for a 100mm cv? for gsf ECP etc.

Last time I purchased one from GSF the joint would not fit (it was about about 10mm to wide). Are there different size 100mm inner CV joints?

Thanks

[Pricie]

Sounds like you might have the 90mm shafts.

VW did 2 sizes, 90mm and 100mm flanges. Afaik, the 100mm shafts were only fitted to GTi’s and very late cars.

Is your engine the 1.8 carb lump? as i think these had 90mm shafts.

[blue95]

The sfat had 90mm inner CVs fitted, I bought 100mm ones from GSF, but htey would not fit.

The were too wide and were not able to physically sit down far enough to get the snap ring on the end (even with the bottom concave washer removed).

[Chris S]

They wont fit, you need the very late G2 Syncro shaft or you can blob a weld on to keep the joint onto the end of the shaft.

[blue95]

quote:

---

Originally posted by Chris S

They wont fit, you need the very late G2 Syncro shaft or you can blob a weld on to keep the joint onto the end of the shaft.

---

Cheers again!

A mate recommended taking them to a machine shop to have another groove cut in on the lathe.

[no such user]

think you’ll find tghere isn’t enuff shaft to cut a groove into blob of weld works very well tho

[no such user]

the other option is use 90mm cv’s and change the drive flange on the gearbox

[blue95]

Cheers fellas will keep that as my last resort

[Chris S]

I dont think that there are any 90mm drive flanges available for an 02C box, are there?

[no such user]

presumed was rod change as carbed was mentioned,

[Author]

Posts