- This topic has 3 voices and 5 replies.
-
Posts
-
So after removing a chunk of ziptie from inside the carb [:0] I think I need to set it up properly. I’d follow the setup advice in this topic but I’m honestly not sure where the mixture / idle screws are on the carb.
Does anyone have any photos of them in-situ? I think I found the idle screw (on the front right of the carb, recessed in a hole), but I’m not sure if it’s idle or mixture.
http://www.piercemanifolds.com/category_s/234.htm – this should help!
Found this – http://www.vwsyncro.co.uk/data/forums/topic.asp?TOPIC_ID=1384 – though interestingly the mixture screw seems to be on the opposite side on mine…! Adjusting it now… [
]Done! Much better. Syncro now has a stereo that works (and keeps the missus entertained!) – ready for a trip down to somerset today [
]I’ve been looking for that idle screw for a while now, hopefuly my Miles per Gallon will get better, thanks for the posts Chris and Phil…was ready to go back to Pierburg
- You must be logged in to reply to this topic.
