Corrado haldex

[vrt]

just received my haldex standalone controller

[vr6will]

What controller is that?

From F-Town Streetmachines?

[vrt]

yes it is from F-town

[vr6will]

looks like a nice piece of kit, spec looks impressive too

[vrt]

Yup I can’t wait to install it

[jofg60]

think im going to run the f-town controller. looks and sounds good

[vrt]

the guys started to tear down the rear end

[vrt]

Been trying to remove the undercoating from the syncro floor and found it to be to difficult to remove. So sending out to get acid dipped
stay tuned

[vrt]

got the rear section back from the acid dip. Now it’s time to start cutting the spot welds out

[vrt]

ready to place into the car

[vrt]

he corrado floor is out

the new floor will be in place tomorrow. Seems that it’s not a perfect fit about 1″ on each side needs to be cut out so that it fits

[vrt]

I have lots of new pic to show what really need to cut cut out on the passanger side. There is a extra reinforcement on corrados that need to get cut out or trimmed back to help slid the side panel into place.

The floor is now in it’s proper place. It’s been tacked into place so that we can test fit the subframe and make sure everything is level. Once it’s all ok. The crew will weld up everything tight

[vrt]

[vrt]

Here are pics of the floor underneath. It still has to lower a bit

[vrt]

Once the floor is all in place. Next will be getting a hole for the fuel system
Like this photo

[Author]

Posts